MeCreator2-Filament-Guide

MeCreator 2 Filament Guide.

What you Need!
1 x Printed Filament Guide
1 x PTFE Teflon Tubing OD 6 mm ID 4 mm 20 mm long.
1 x PTFE Teflon Tubing OD 4 mm ID 2 mm 400 mm (alter length if necessary)

Firmly fit one end of the 4 mm tubing into the filament guide.
Mount the guide on the right hand side, so it does not foul any plugs/wires.
Slip the 6 mm tube over the tube on the extruder..
After you load your filament, just plug the 4 mm OD tube into the 4 mm ID tube as seen in picture.