PrintRbot + 2.1 Digital Micrometer holder

Holds the cheap micrometer available on amazon in place so you could precisely lever your print bed.,

MADE IN USA

Print 2 parts

Usage Notes:
1. I am able to get my bed +-0.02mm level in around 2-5min or even less

2. Make sure to heat up the bed before leveling since it could warp,

2.1 Set your Z at around 10-20 so the device is under minimum stress for best result

3. Ride Y up and down until you get same results all the way across
(I have noticed that my aluminium bed i