Thingiverse
41mm Prop Spinner - for 9" prop
by dalgibbard
57
Downloads
34
Likes
1
Makes
This is a minorly amended version RedbeardPete's EFX Prop Spinner, specifically:
* Simplified the base to remove skirt (which required a lot of support material), and to fill in the cutout area where the cone originally sat
* Removed the bottom edge of the cone which would normally sit in the base's cut-out. Now the pieces just sit flat instead. Simplifies printability further, and increases rigidity of the base (the two screw fixtures will be sufficient to hold the pieces in alignment).
* In
* Simplified the base to remove skirt (which required a lot of support material), and to fill in the cutout area where the cone originally sat
* Removed the bottom edge of the cone which would normally sit in the base's cut-out. Now the pieces just sit flat instead. Simplifies printability further, and increases rigidity of the base (the two screw fixtures will be sufficient to hold the pieces in alignment).
* In
Sign in to leave a comment
Sign in