Thingiverse
HICTOP Prusa I3 Z-Axis Bearing
by scherle
37
Downloads
16
Likes
0
Makes
On the stock HICTOP Prusa I3 printer, the Z-axis threaded rod is supported by sticking it through a hole in an acrylic part. This is a bad idea because 1) HICTOP's tolerances on these parts are not very good and 2) the rod will wobble and wear against the acrylic.
If yours shatters (like mine did) and you just want to replace it, you can print this replacement part.
HOWEVER, since you are doing this anyway, why not do it right? You can replace this part with one that uses an inexpensive 8m
If yours shatters (like mine did) and you just want to replace it, you can print this replacement part.
HOWEVER, since you are doing this anyway, why not do it right? You can replace this part with one that uses an inexpensive 8m
Sign in to leave a comment
Sign in