Thingiverse
i3 Titan mount system
by thsturgill
10
Downloads
10
Likes
0
Makes
3/16/17 Modified plate&chain to eliminate screws and open channel for belt. This was original design, with the chain mount removed to allow better printing orientation. However along the way I also beefed it up, so it should be OK in this orientation. Side notches are to hold cable tie. Bearing blocks resized to not allow any play after bearing installed. Note that over/under extrusion can affect this.
3/14/17
I am designing this to re-build a clone printer onto a Prusa single frame us
3/14/17
I am designing this to re-build a clone printer onto a Prusa single frame us
Sign in to leave a comment
Sign in