Thingiverse
Dell R710/610 SFF Drive Tray
by jwhostetler
104
Downloads
67
Likes
0
Makes
Ready to assemble Dell SFF Drive tray.
Everything was printed with 20% infill with basic settings using PLA. Modeled from the ground up using a Dell OEM drive tray.
The handle is plenty strong and allows you to pull the drive in and out easily. One rail does have a cut out so the drive can slide all the way into the back plane. All you need are 4 screws just about any should work. The handle/connector is a tight fit into the two side rails which give it some extra strength.
I had some o
Everything was printed with 20% infill with basic settings using PLA. Modeled from the ground up using a Dell OEM drive tray.
The handle is plenty strong and allows you to pull the drive in and out easily. One rail does have a cut out so the drive can slide all the way into the back plane. All you need are 4 screws just about any should work. The handle/connector is a tight fit into the two side rails which give it some extra strength.
I had some o
Sign in to leave a comment
Sign in