Thingiverse
Freelancer Battleship Osiris Printable Sections
70
Downloads
38
Likes
0
Makes
Five sections of the Battleship Osiris that can be printed and assembled into a final product. Each one is 100mm in length to fit on a 120x120x120mm print bed with ease. I printed them in vertical orientations with full supports on cura just to be safe. only a 10% fill density was needed. Temps are dependent on your plastic, the one I had worked well at 200C with 50C on the bed. Layers were 0.1 and all other settings were defaults for Cura.
Check out the newly made Freelancer group
http://w
Check out the newly made Freelancer group
http://w
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in