Thingiverse
Hypercube 3D Printer - Adjustable/Extended Fan Duct (For clone/different hotends)
by Sterminare
34
Downloads
23
Likes
0
Makes
I built Tech2C's Hypercube, but the fan duct is too short for my e3D v6 Clone. Its blowing directly onto the heater block. If you decide to make one, please upload a make. I would love to see how yours turn out
With this, the fan duct can be adjusted 2mm up or down by sliding the screw in the slot.
At it's highest, it's the same as the default duct. At it's lowest, it's approximately 2mm below the default. I have mine adjusted to ~1.5mm below default.
I also removed 2mm from the top of
With this, the fan duct can be adjusted 2mm up or down by sliding the screw in the slot.
At it's highest, it's the same as the default duct. At it's lowest, it's approximately 2mm below the default. I have mine adjusted to ~1.5mm below default.
I also removed 2mm from the top of
Sign in to leave a comment
Sign in