Thingiverse
FFCP Umbilical Cord Support (No Supports Needed)
by JustGoMedia
42
Downloads
15
Likes
0
Makes
I tried to customize Dr. Lex's umbilical support for the FFCP without supports through Thingiverse Apps and it was a complete fail. I decided I'd redesign the part from the ground up.
This thing requires no supports and may in fact make for a stronger part because of it. Prints in under an half hour (bonus for my attention span!) with an economical use of the plastic. Depending on your machine a cable tie may not be entirely necessary but there are notches for two cable ties, I only needed on
This thing requires no supports and may in fact make for a stronger part because of it. Prints in under an half hour (bonus for my attention span!) with an economical use of the plastic. Depending on your machine a cable tie may not be entirely necessary but there are notches for two cable ties, I only needed on
Sign in to leave a comment
Sign in