Thingiverse
Skytank 210 / QAV 210 rear xt60 mount with TX pigtail mount with RX tie wrap mount and holes for rx wires
by hollifm
5
Downloads
3
Likes
0
Makes
Created a Skytank 210 rear xt60 cable adapter with TX pigtail cutout and a rx tiewrap with pass thru holes for the rx wires to run along the tiewrap.
Should be an all in one for the rear end.
Note. You might need to sand out the tx mount. I used hard material for the 3d print and had to sand it. Or you might use a softer material for the print and it be a non issue.
Should be an all in one for the rear end.
Note. You might need to sand out the tx mount. I used hard material for the 3d print and had to sand it. Or you might use a softer material for the print and it be a non issue.
Sign in to leave a comment
Sign in