Case / Enclosure for Adafruit's ESP8266 Breakout Board (Huzzah)

Best used with male headers soldered top-side (though now available with bottom cutout too). Try using the asterisk cutout to organize if free wiring.

#### Printing notes

This case was designed around a 0.48mm extrusion width. This gives the features on the case a bit of added strength. If the case isn't printing quite right, try adjusting the slicer's extrusion width.

#### Buttons

The two buttons are held in by a toe-like lip (so if the case gets flipped upside down the buttons don'