Thingiverse
3 Axis Gimbal for GoPro Stereo
by ACE1027
5
Downloads
8
Likes
0
Makes
Work in progress....
My design is using iPower Motor GBM2804 100T motors.
I had to use a step bit to clean the circular holes.
My original remix design had a flaw where I removed the hole that allowed for a bearing rod. This clamped the mount of the arm down on the bearing, locking it up in the process. I then added the hole back into the design on one end of each arm because it was only locking up one side of the motor. This hole needed a little extra space so I drilled it out. I figure
My design is using iPower Motor GBM2804 100T motors.
I had to use a step bit to clean the circular holes.
My original remix design had a flaw where I removed the hole that allowed for a bearing rod. This clamped the mount of the arm down on the bearing, locking it up in the process. I then added the hole back into the design on one end of each arm because it was only locking up one side of the motor. This hole needed a little extra space so I drilled it out. I figure
Sign in to leave a comment
Sign in