E3D Sensor mount for the Hypercube

An easier and tighter way to mount the LJ12A3-4-Z Inductive Proximity Sensor to the Hypercube 3d printer.

Note. You might find it too loose or tight and need to scale it a bit smaller or larger to fit your probe. Best to test before mounting it to the main e3d x-axis mount. Clip it in and out a few times before hand.

##### Parts

Uses the same screw size fitting as the original mount. (M3 screw)

##### Directions

My approach is to move nozzle down at the centre of the bed (about a