Thingiverse
Corner bracket for hanging stuff
by davepix
7
Downloads
7
Likes
0
Makes
a corner bracket to hang stuff from a 1/2" dowel
one end of the dowel I had was smaller than 1/2" so the hook end is smaller, scale up or make your own adaptation.
It is designed to have a spring in the hole at the top extend to the retaining ring on the dowel. You can drill holes to set the position which tensions the spring or use a zip tie to hold it in place.
The dowel is held in place using a 9d finish nail for a pin and same dropping one down the hole at the top for the spring.
one end of the dowel I had was smaller than 1/2" so the hook end is smaller, scale up or make your own adaptation.
It is designed to have a spring in the hole at the top extend to the retaining ring on the dowel. You can drill holes to set the position which tensions the spring or use a zip tie to hold it in place.
The dowel is held in place using a 9d finish nail for a pin and same dropping one down the hole at the top for the spring.
Sign in to leave a comment
Sign in