ANET A8 | Rear Bed Level Sensor Holder 12mm - Thicker for single piece mounting

As i use a 12mm Inductive Sensor (LJ12A3-4-Z/BX) i had to mount it only on the lower mounting point as it is not long enough to mount it in upper and lower one.
The Sensor would not have been long enough to bring it down to sensing range in both mounts

So i decided to make the Mount plate a bit thicker for more stability.
It is not really needed as the Sensor doesnt move that much, and it is ok in only 1 mounting point.
But always: Better safe then sorry ;)

Hope this helps