MP Select Mini Strain Relief Extruder Heater / Thermocouple

If you watch closely during large movements in the X-direction, you will see both the Extruder Heater and Extruder Thermocouple wires move and are being fatigued / worn-out at the heater block. This "strain relief" uses two zip ties to secure the wires and prevent fatigue at the point of termination.

Bowden Tube "Push-to-Connect" fitting must be removed by pulling the fan and using a 1.5mm allen key to loosen the clamp holding in the Bowden Tube Push-to-Connect fitting.

Create extra sla