Thingiverse
Holder for shower wiper
by WalterSKW
2
Downloads
4
Likes
0
Makes
Holder for an up to 250mm shower wiper.
Glued with tape to the wall.
**Print**
S3D factory file included for a 0,6mm nozzle.
Print it as shown in the pictures on a raft or a brim to stabilize it on the bed. No support needed then. Infill is not critical at all.
Glued with tape to the wall.
**Print**
S3D factory file included for a 0,6mm nozzle.
Print it as shown in the pictures on a raft or a brim to stabilize it on the bed. No support needed then. Infill is not critical at all.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in