Nintendo Switch Hylian Shield Stand

I loved the Nintendo Switch stand that I saw scrolling through thingiverse, but being the Zelda fan I am, I decided that it needed some custom logo on it. So, I did just that.

EDIT: I added air-intakes in the back of the stand for the air-intakes on the back of the switch.

Source:
http://www.thingiverse.com/thing:2157876

NOTE: Place it on its side to print it, as done in the picture above.

Printer Settings:
Layer Height: .25

Fill Density: 50
NOTE: Can be done at 15-25 infill.