Thingiverse
30.5mm FC/OSD/PDB Spacer
by JerryBoi831
25
Downloads
14
Likes
0
Makes
Meant to be printed in tpu to save spacers and make the build loads easier. Just set one on the bottom of fc to seperate from frame then another on top and as many as you need following for anymore boards stacked up nice and clean! Print in your fav color for added eye candy pop.
30.5mm spacing with holes for 3mm screws. run screws from under all the way to top and screw down with nylon nut. will add vibration dampning and get rid of any possible electronics shorting
BEST TO PRINT IN TPU
30.5mm spacing with holes for 3mm screws. run screws from under all the way to top and screw down with nylon nut. will add vibration dampning and get rid of any possible electronics shorting
BEST TO PRINT IN TPU
Sign in to leave a comment
Sign in