Thingiverse
DMS DP5 - 40mm fans duct and holders, auto-leveling sensor mount
by mexusbg
8
Downloads
6
Likes
1
Makes
40mm fans mount for DMS DP5. Original 30mm fan is a joke.
I recommend using hot-end thermal isolation if you use very powerful fans.
To print this you need a printer with good bridging capabilities.
You can replace the original part, inductive sensor is in the same position.
I use 40x40x20 Sunon MagLev Fans
I recommend using hot-end thermal isolation if you use very powerful fans.
To print this you need a printer with good bridging capabilities.
You can replace the original part, inductive sensor is in the same position.
I use 40x40x20 Sunon MagLev Fans
Sign in to leave a comment
Sign in