Thingiverse
TCU Horned Frogs Fidget Spinner - Wingnut2k
by wingnut2k
14
Downloads
10
Likes
1
Makes
As per a request, here are two TCU Horned Frog fidget spinners. One spinner has the horned frog as a relief and the other has it as a bumpout. This spinner uses (3) 1/2" ball bearings and one 608 bearing. These spinners is only about 3-1/8" in diameter overall.
I would heat up the print and ball bearing with warm water and the bearings will slip in.
TY to bigmikewarren for allowing me to use his picture.
I would heat up the print and ball bearing with warm water and the bearings will slip in.
TY to bigmikewarren for allowing me to use his picture.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in