Thingiverse
MPSM X gantry brace
by Leesamn
168
Downloads
77
Likes
1
Makes
The original didn't match the screw pattern on my MP Select Mini so I altered it based on my printer's measurements. I oversized the holes on the left screws because the original screws installed in my printer were very short and probably wouldn't fit the brace unless i countersunk the hole to one or two layers.
Added a cap to the rod holder as my bearing rod had a slightly rough cut and i didn't want to slice myself on it. I resized the screw holes to match hardware i had on hand. This seems
Added a cap to the rod holder as my bearing rod had a slightly rough cut and i didn't want to slice myself on it. I resized the screw holes to match hardware i had on hand. This seems
Sign in to leave a comment
Sign in