CR-10 Fine Z-Axis Endstop Adjustment

This is my crude Z-axis endstop adjustment that allows for a fairly fine adjustment of the height of your Z-axis on the CR-10.

BOM:
1x M4 x 5 brass threaded insert
1x M4 x 20
1x M4 hex nut
1x M4 locknut

1. Use a soldering iron to press the threaded insert into 5mm hole provided for it. Be careful not to get any plastic inside the insert. The inserts I used have a 5mm outer diameter. If yours have a different OD, you will have to adjust the hole accordingly. I made a model using only he