Thingiverse
Cheap Bed Level Sensor (touch)
by labidus
1
Downloads
1
Likes
0
Makes
Cheap BED Level Sensor!! This will only use the sensor wires which don't really have much voltage (around 0.5v). Basically it's a very simple switch, when the 2 m3 screws touch together it signal the board.
Only need 2 m3 screws, 2 washers, one spring, 2 nuts and a print part! Total cost less then 1$ :)
1. Print the STL provided in this thing. This sensor mount is 12mm diameter, will be able to be mounted on compatible "inductive sensor" or you can screw it where you want using the 2 holes
Only need 2 m3 screws, 2 washers, one spring, 2 nuts and a print part! Total cost less then 1$ :)
1. Print the STL provided in this thing. This sensor mount is 12mm diameter, will be able to be mounted on compatible "inductive sensor" or you can screw it where you want using the 2 holes
Sign in to leave a comment
Sign in