Thingiverse
Rob's CarbonX Deadcat-Frame Whoop
by robthomson
26
Downloads
23
Likes
0
Makes
This is a tough as nails Deadcat-Frame whoop that I designed to be printed in CarbonX Nylon filament.
It flies stupid well.
No ducts - because it is meant to be flown outdoors. To be honest.. if you want a ducted whoop - then the e010s frame or similar is hard to beat!
I print with carbonx nylon filament. 0.15 layer height and 10% infill.
It is structurally sound and should print well and provide good strength with any filament - although I have not personally tested anything but T
It flies stupid well.
No ducts - because it is meant to be flown outdoors. To be honest.. if you want a ducted whoop - then the e010s frame or similar is hard to beat!
I print with carbonx nylon filament. 0.15 layer height and 10% infill.
It is structurally sound and should print well and provide good strength with any filament - although I have not personally tested anything but T
Sign in to leave a comment
Sign in