Thingiverse
Laser cut Arduino enclosure open top
by RikkiNelson
35
Downloads
18
Likes
0
Makes
I needed this, and desided to make it just a little bit wider.
The top is now open, so you can have easy accsess.
++ this is now in A4 sheet and devided for K40 laser and similar...
from teabot (cudos and like):
3) Cut the design from 3mm acrylic. Slot the pieces together - excluding the lid!
4) Slide in your Arduino board, USB port first. Secure the board to the base plate with fixings of your choosing. I used some M3 bolts with insulating washers. But you could use PCB stand-offs if
The top is now open, so you can have easy accsess.
++ this is now in A4 sheet and devided for K40 laser and similar...
from teabot (cudos and like):
3) Cut the design from 3mm acrylic. Slot the pieces together - excluding the lid!
4) Slide in your Arduino board, USB port first. Secure the board to the base plate with fixings of your choosing. I used some M3 bolts with insulating washers. But you could use PCB stand-offs if
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in