Thingiverse
Spool Holder PrintaLot
by juan15pablo
7
Downloads
6
Likes
0
Makes
This is a totaly printed spool holder.
It was printed with a CEL Robox.
The X were printed with 0.3mm layer tickness, and the rest with 0.2.
It take about 2 hours each X, and 2 hours the semicylinder with the brackets.
The only who need support is the semicylinder.
It was desing for PrintaLot spool (25mm inner diameter and 200mm total spool diameter).
It was printed with a CEL Robox.
The X were printed with 0.3mm layer tickness, and the rest with 0.2.
It take about 2 hours each X, and 2 hours the semicylinder with the brackets.
The only who need support is the semicylinder.
It was desing for PrintaLot spool (25mm inner diameter and 200mm total spool diameter).
Sign in to leave a comment
Sign in