Thingiverse
Thug Squeeler and Thug SKUNK220
by RM_3D
2
Downloads
1
Likes
0
Makes
Angel Combo Read file names
45 deg.
35 deg.
Tight fit on the FPV cam. Loosen the standoff when sliding it on so you get more space, then re tighten. Glued the cam with hot glue. Not yet tested on the SKUNK 220, but should fit. Print time may differ. The fpv-cam holder should be 15-25 min. Print time on both on medium quality was Ca 1h 15min.
45 deg.
35 deg.
Tight fit on the FPV cam. Loosen the standoff when sliding it on so you get more space, then re tighten. Glued the cam with hot glue. Not yet tested on the SKUNK 220, but should fit. Print time may differ. The fpv-cam holder should be 15-25 min. Print time on both on medium quality was Ca 1h 15min.
Sign in to leave a comment
Sign in