Thingiverse
Pegboard Insert Screwdriver Holder
by neilmac
42
Downloads
31
Likes
1
Makes
I made this insert out of frustration after the only screwdrivers I had would fall right through the rings on pegboard screwdriver holders and get stuck. These inserts hold either 1 screwdriver in the middle, or two smaller ones side by side in the same ring. The small holes have a diameter of 0.2 inches, and the large center hole has a 0.32 inch diameter. The inserts fit into standard circular pegboard screwdriver holders with ~3/4" rings. A small bump on the bottom holds the insert in pla
Sign in to leave a comment
Sign in