Thingiverse
Y Carriage riser for Anet A8 (Reprapchampion carriage)
by 3dbcreations
11
Downloads
4
Likes
0
Makes
This is a riser for this Y carriage from RepRapChampion: http://bit.ly/2oBznGf
On some printers (specifically the Anet A8) the carriage sets too low and would hit the Y axis motor without some sort of riser. This one is just tall enough for it to clear the bed, so you don't lose much height. You'll need 3 or 4 of these depending on how many bearings you're using.
On some printers (specifically the Anet A8) the carriage sets too low and would hit the Y axis motor without some sort of riser. This one is just tall enough for it to clear the bed, so you don't lose much height. You'll need 3 or 4 of these depending on how many bearings you're using.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in