Thingiverse
Dovetail Puzzle 2
by pozzy
7
Downloads
5
Likes
1
Makes
Hi makers,
I thought you may like this other puzzle similar to my Dovetail Puzzle 1 but this time with a convex inner joint.
Print with minimum 100 micron layer height with about 20% infill. I use 3 outer shells and 6 top and bottom layers at 100 micron. The tollerances are quite tight so you need to have your printer dialed in. You will also need a 4mm dia 2mm thick disc magnet and a ~9mm pin (I used a section of an m4 screw cut and sanded to length). The disc magent is placed in the base
I thought you may like this other puzzle similar to my Dovetail Puzzle 1 but this time with a convex inner joint.
Print with minimum 100 micron layer height with about 20% infill. I use 3 outer shells and 6 top and bottom layers at 100 micron. The tollerances are quite tight so you need to have your printer dialed in. You will also need a 4mm dia 2mm thick disc magnet and a ~9mm pin (I used a section of an m4 screw cut and sanded to length). The disc magent is placed in the base
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in