Reach3D E3Dv6 & BLTouch Hot End Mount

This mount is for Reach3D printers with an E3Dv6 hot end and a BLTouch sensor. It's a remix of kalrog2's excellent minimalist design. I adjusted the hot end mount a few millimeters lower and closer to the carriage to accommodate the E3Dv6. I also removed some material from the BLTouch mount and added a center hole for fine tuning of the sensor. Finally, I added cable tie slots on either side of the nozzle to help secure the wiring.

Set the probe offset for the BLTouch to X: -32

UPDATE