Thingiverse
223 Reloading Tray / Case Drying Rack v2
von joelwinsagain
37
Downloads
37
Likes
0
Makes
v2.1 update: removed some unnecessary small geometry
I recently started using an ultrasonic cleaner for my cases and wanted a better way to dry them thoroughly, so I made a stacking reloading tray with slots for air flow so I could use a fan.
Version two of my case reloading tray has better flow, and makes contact with less of the surface of the case, allowing for better drying. I've only printed one so far as proof of concept before uploading, but I used the same method for stacking, so it should work just as well, if not slightly better, since I use larger feet and deeper grooves. (edit: I've printed a second, and am satisfied with the way it stacks) The big drawback is that it takes considerably longer to print, which is the main thing I'll be working on for version 3.
As before, I'm open to suggestions for improvements that can be implemented in the next version
I recently started using an ultrasonic cleaner for my cases and wanted a better way to dry them thoroughly, so I made a stacking reloading tray with slots for air flow so I could use a fan.
Version two of my case reloading tray has better flow, and makes contact with less of the surface of the case, allowing for better drying. I've only printed one so far as proof of concept before uploading, but I used the same method for stacking, so it should work just as well, if not slightly better, since I use larger feet and deeper grooves. (edit: I've printed a second, and am satisfied with the way it stacks) The big drawback is that it takes considerably longer to print, which is the main thing I'll be working on for version 3.
As before, I'm open to suggestions for improvements that can be implemented in the next version
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
