Thingiverse
2230 sized NVME SSD Case
by bonivus
7
Downloads
10
Likes
0
Makes
This is a simple remix at a client's request to shrink the case down to better hold a 2230 sized NVME M.2 form factor SSD module without bouncing around inside it.
As noted from the original, You will absolutely need to use Vase mode (or Spiralize Contour) for it to print hollow.
For Cura, this means:
Inflil: 0% infill
Enable Advanced settings to show Special Settings- Spiralize Outer Contour is hiding there.
Top/Bottom: 0 top layers
Your slicer may vary.
The photo shows the original in the background, and the remix in front.
As noted from the original, You will absolutely need to use Vase mode (or Spiralize Contour) for it to print hollow.
For Cura, this means:
Inflil: 0% infill
Enable Advanced settings to show Special Settings- Spiralize Outer Contour is hiding there.
Top/Bottom: 0 top layers
Your slicer may vary.
The photo shows the original in the background, and the remix in front.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!