Thingiverse
Customizable Bed Level Calibration Test
by timfou
320
Downloads
156
Likes
0
Makes
A customizable model to test areas of your heatbed for proper first-layer printing.
**How to use:**
1) print the model
2) check that first layer "squish" is the same on all the circles
3) raise/lower the nozzle at the left, right, front or back of you bed to adjust
The included STL model has nine circles which are 0.3mm high as I tested with 0.2mm layers with a first layer printed at 150% (0.3mm) and I only wanted to lay down a single layer for this test.
You can customize this mode
**How to use:**
1) print the model
2) check that first layer "squish" is the same on all the circles
3) raise/lower the nozzle at the left, right, front or back of you bed to adjust
The included STL model has nine circles which are 0.3mm high as I tested with 0.2mm layers with a first layer printed at 150% (0.3mm) and I only wanted to lay down a single layer for this test.
You can customize this mode
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in