Thingiverse
The Penmaker's Friend
por involved6
40
Descargas
17
Likes
1
Makes
A simple chuck that allows you to drill out the center of your blanks by using a standard 3-inch faceplate with a drill chuck on the tailstock. STL included is a single of 4 required, identical jaws.
No more lining things up in the vise for the drill press! Simply take your 3/4" blank and insert or tighten down into the jaws and crank away.
Jaws have two relief bands for pipe clamps, but I haven't seen a need for them yet, as this process is usually on the slowest setting on the lathe. Use your brain when putting something like this on a lathe! Keep those RPMs LOOWWWW.
No more lining things up in the vise for the drill press! Simply take your 3/4" blank and insert or tighten down into the jaws and crank away.
Jaws have two relief bands for pipe clamps, but I haven't seen a need for them yet, as this process is usually on the slowest setting on the lathe. Use your brain when putting something like this on a lathe! Keep those RPMs LOOWWWW.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
