Thingiverse
Printrbot Play Extruder Shroud
by k4en
10
Downloads
6
Likes
0
Makes
I've had an ongoing project to improve the part cooling on my Printrbot Play. I've finally got the solution I needed. This shroud incorporates the standard 20x20mm square fan for extruder cooling and a 50mm radial fan for part cooling.
The shroud is tapped for 3mm button head screws in four places to secure the fans. Note that I ground down the radial fan tabs about 2mm just under the screw heads so the screws do not extend beyond the face of the fan. This provides clearance to the Printrbot
The shroud is tapped for 3mm button head screws in four places to secure the fans. Note that I ground down the radial fan tabs about 2mm just under the screw heads so the screws do not extend beyond the face of the fan. This provides clearance to the Printrbot
Sign in to leave a comment
Sign in