Thingiverse
IKEA Stuva Cabinet Filament Guide
by Nuigh
53
Downloads
17
Likes
0
Makes
A simple filament guide for IKEA Stuva based cabinets. Inner hole diameter 4 mm, outer hole 6mm.
TLDR:
1. Print out **TWO** parts.
2. Drill a single 6mm hole in the middle of the IKEA Stuva cabinet ceiling. (Maybe a tiny bit forward, rather than center - at least for Duplicator i3 the filament tends to grind on the frame if it comes directly from above.
3. Place the two parts from the opposing sides to the hole. Make them hold using superglue.
TLDR:
1. Print out **TWO** parts.
2. Drill a single 6mm hole in the middle of the IKEA Stuva cabinet ceiling. (Maybe a tiny bit forward, rather than center - at least for Duplicator i3 the filament tends to grind on the frame if it comes directly from above.
3. Place the two parts from the opposing sides to the hole. Make them hold using superglue.
Sign in to leave a comment
Sign in