Thingiverse
2020 Extrusion Cable Tie Mounts
by JMadison
252
Downloads
114
Likes
1
Makes
Cable tie mounts for 20x20 aluminum extrusion rails.
Five different versions: 45, 90, 135 and 180 to the extrusion, and a round version that has no spline so it can be set at any angle. Because the round version has no spline, it can also be used on any flat surface.
These are designed for cable ties less than 3mm wide.
The hole is for M3 flathead screws.
These should be printed without support.
Five different versions: 45, 90, 135 and 180 to the extrusion, and a round version that has no spline so it can be set at any angle. Because the round version has no spline, it can also be used on any flat surface.
These are designed for cable ties less than 3mm wide.
The hole is for M3 flathead screws.
These should be printed without support.
Sign in to leave a comment
Sign in