Modified Endplate for Fully Printable Eggbot

This is a slightly modified endplate for Glasswalker's Revised Fully Printable Eggbot (Spherebot) http://www.thingiverse.com/thing:20398), with the top corner removed to allow the pen to travel further. It's also been run through netfabb to clean it up.

Finally, there's the "standoff" version, which places four tabs one side (either the outside of the left endplate, or the inside of the right endplate) to snap in a 1.8" x 2.5" that I soldered up to control the eggbot with a Modern Devices RB