Thingiverse
XT60 and 6S Balance Plug Bulkhead
by jocampo
48
Downloads
32
Likes
1
Makes
Created this to connect a parallel charging board inside a .50cal Ammo box and an external lipo charger.
For the bulkhead, I used ABS at 30% infill and 100% infill for the cable hook. I also scaled up by .30% to factor in ABS shrinkage. You may need to play around with your settings to get the plugs in to fit. You can use the "XT60_Bulkhead_Test" file to test you printer settings.
As for the balance plug, there is a lip the plug rest on. Install from the inside out. Depending on the exten
For the bulkhead, I used ABS at 30% infill and 100% infill for the cable hook. I also scaled up by .30% to factor in ABS shrinkage. You may need to play around with your settings to get the plugs in to fit. You can use the "XT60_Bulkhead_Test" file to test you printer settings.
As for the balance plug, there is a lip the plug rest on. Install from the inside out. Depending on the exten
Sign in to leave a comment
Sign in