Thingiverse
Parametric Spoolholder for Anet A8 type printers
by svhb
4
Downloads
3
Likes
0
Makes
Very preliminary parametric version of my Dovetail Spool Mount for Anet A8 and similar printers.
Generate test pieces by setting Piece to 4 and 5. Use these to adjust "looseness" parameter.
Looseness of 0 will probably be impossible to assemble, but this of course depends on your individual printer. Mine is not calibrated very well, so I use a looseness of around 0.2. I think a well adjusted printer might work with about 0.1. Print the two test pieces with varying looseness until you get a
Generate test pieces by setting Piece to 4 and 5. Use these to adjust "looseness" parameter.
Looseness of 0 will probably be impossible to assemble, but this of course depends on your individual printer. Mine is not calibrated very well, so I use a looseness of around 0.2. I think a well adjusted printer might work with about 0.1. Print the two test pieces with varying looseness until you get a
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in