BCP Go-Ped GSR Frame Clamp

This model is a cable clamp for a Go-Ped GSR Scooter. It is designed to use M3 nuts and bolts. To assemble the clamp you will need:

2 M3 x 12 cap screws
2 M3 nylon lock nuts

I recommend using a minimum of 10-20% infill in addition to 1.2mm thick walls as well as a 1-2mm thick top and bottom layer. So far I have printed these in black PLA with success.

Make sure not to over-tighten the bolts as this can break the plastic!