Thingiverse
Kossel Tri-Fan Groove Effector
7
Downloads
4
Likes
0
Makes
I bought a Sintron Kossel Kit off ebay and the push rods fish eye joints were way too large for the supplied effector plate, limiting my print radius to around 100mm and causing binding on anything larger. Fortunately that was big enough to print AndreaDV's Groove Effector plate, after hooking it up and printing a benchy, not only did I get the best result I'd seen yet plus a much larger print radius, I noticed that the side with the fan looked much better than the side without the fan, so I des
Sign in to leave a comment
Sign in