Thingiverse
L96 barrel spacer
by ECO9FPV
139
Downloads
125
Likes
0
Makes
This is a basic L96 barrel spacer. It can be printed from 100% to 50%, it depends on your printer.
I printed it 100% with 0.3mm layer and 0.4 nozzle.
Flexible filament prefered, as it's a little bit wider and thiner to hold the inner barrel into the outer barrel. If you print it with PLA/ABS it's not gonna fit!
I printed a 15cm tower (change the Z value) and then you can cut it by cutter the size you preffer. By default it's 1cm.
To end with the smal filament it can get during travel it's go
I printed it 100% with 0.3mm layer and 0.4 nozzle.
Flexible filament prefered, as it's a little bit wider and thiner to hold the inner barrel into the outer barrel. If you print it with PLA/ABS it's not gonna fit!
I printed a 15cm tower (change the Z value) and then you can cut it by cutter the size you preffer. By default it's 1cm.
To end with the smal filament it can get during travel it's go
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in