Thingiverse
T-Rex 450 Tail Stabilizer
by jorgecam
21
Downloads
23
Likes
1
Makes
This is a tail stabilizer for T-REX 450 or clone helicopter.
The 3 mm thick one is lighter but a bit flexible when printed in PLA. If no vibration occurs I think it is a good option, because it can absorb some shock before braking down.
The 5 mm thich is solid as rock if printed in PLA, as much as the original carbon fiber one. It will better protect the tail rotor and blades in a crash, but it will also transmit the shock to the tail boom.
If no vibration is observed when flying, I pre
The 3 mm thick one is lighter but a bit flexible when printed in PLA. If no vibration occurs I think it is a good option, because it can absorb some shock before braking down.
The 5 mm thich is solid as rock if printed in PLA, as much as the original carbon fiber one. It will better protect the tail rotor and blades in a crash, but it will also transmit the shock to the tail boom.
If no vibration is observed when flying, I pre
Sign in to leave a comment
Sign in