Thingiverse
W1209 Temperature switch double housing with stand, for 2 boards.
by Makeoneortwo
31
Downloads
21
Likes
0
Makes
W1209 Temperature switch double housing with stand, for 2 boards.
Glued with super-adhesive. I have provided holes for the LEDs in the housing; This is then covered with insulating tape since I was the LEDs were too bright. The temperature sensors were soldered on the backside of the board to prevent the cable of the front. To lead the cables to the rear, holes must be drilled at the desired positions.
W1209 Temeraturschalter Doppel Gehäuse mit Ständer, für 2 Platinen.
Verklebt mit Sek
Glued with super-adhesive. I have provided holes for the LEDs in the housing; This is then covered with insulating tape since I was the LEDs were too bright. The temperature sensors were soldered on the backside of the board to prevent the cable of the front. To lead the cables to the rear, holes must be drilled at the desired positions.
W1209 Temeraturschalter Doppel Gehäuse mit Ständer, für 2 Platinen.
Verklebt mit Sek
Sign in to leave a comment
Sign in