Miniature RPi Camera enclosure / case (M2.5 edition)

Fits this product sold by Adafruit: https://www.adafruit.com/products/1937

Extrusion width: 0.48mm

## Printing notes

This case was designed around a 0.48mm extrusion width. This gives the features on the case a bit of added strength. If the case isn't printing quite right, try adjusting the slicer's extrusion width.

## Enclosure Hardware (Bill of Materials)

2x M2.5 x 16mm
2x M2.5 Hex Nuts or 2x M2.5 Nylock Nut

The ones used for testing were sourced from Trimcraft Aviation RC