Thingiverse
Dynamix by AirpixFPV Shroud
by CooperLytle
1
Downloads
0
Likes
0
Makes
This is a nice shroud to protect electronics from grass and twigs! it slides right on and your camera can be held by the pegs in the side. I use a Runcam Owl and it sits at about 35 degrees. the tolerances are pretty close so if your printer isn't very accurate I would elarge the standoff holes. Also you should only need one support. This must be PRINTED UPSIDE DOWN relative to when it is on the drone.
Sign in to leave a comment
Sign in