Thingiverse
CoreXY x FT5 carriage
by tomasro
156
Downloads
96
Likes
0
Makes
An open platform more similar to what the FolgerTech 5 printer has for for the CoreXY v2.0 frame.
Tip for installing belt:
-install one side with minimal excess sticking out on sides
-pull the other sides though a partially screwed down clamp
-screw down top until it pinches the belt, and then do the same for the bottom
-pull belts tight and screw down top and bottom more
-repeat until belt can't move anymore and belt holder caps flush with carraige
Tip for installing belt:
-install one side with minimal excess sticking out on sides
-pull the other sides though a partially screwed down clamp
-screw down top until it pinches the belt, and then do the same for the bottom
-pull belts tight and screw down top and bottom more
-repeat until belt can't move anymore and belt holder caps flush with carraige
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in